eSUN 3D TPE-95A on the Prusa XL
Published . Updated .
Print settings and compatibility for eSUN 3D TPE-95A on the Prusa XL, copied from the maker's data.
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
What to set
Set your slicer to
- Nozzle: 230–270 °C (446–518 °F).
- Bed: 35–70 °C (95–158 °F).
- Print speed: up to 100 mm/s.
The maker did not list an enclosure or a hardened nozzle.
Will it work on this printer?
- XL maximums: nozzle 290 °C (554 °F), bed 120 °C (248 °F).
- The listed nozzle temperature is within this printer's reach.
- The listed bed temperature is within this printer's reach.
- Whether an enclosure is required is not listed by the maker.
- A hardened nozzle is not listed by the maker.
Related
Where these numbers come from
Filament: eSUN TPE-95A TDS (CN, file V1.1, document dated 2026.06 v1.0) · checked 21 October 2026
Printer: Prusa MK4S page comparison table · checked 14 October 2026
eSUN 3D TPE-95A (TPE) lists a nozzle temperature of 230–270 °C (446–518 °F) and a bed temperature of 35–70 °C (95–158 °F), drying at 60 °C (140 °F) for 5–7 h, and print speed up to 100 mm/s, from the eSUN TPE-95A TDS (https://www.esunchina.net/uploads/TPE-95A-TDS-CNV1.1.pdf), checked 2026-10-21.
A figure is copied from a named source, and a missing figure stays blank. Methodology.
The comparison table lists the XL at 290 °C (554 °F) / 120 °C (248 °F) with a brass nozzle and multi-material printing by up to five toolheads.
Chamber temperature is listed as 45 °C (113 °F) in the Enclosure, which is treated here as an optional enclosure rather than a stock enclosed chamber.
The XL+ product page checked 2026-10-20 lists a 290 °C (554 °F) nozzle and a heatbed up to 115 °C (239 °F), so this record still uses the MK4S comparison table, which lists the XL at 290 °C (554 °F) and 120 °C (248 °F).