eSUN 3D TPE-95A on the Creality Ender-3 V3 Neo
Published . Updated .
Print settings and compatibility for eSUN 3D TPE-95A on the Creality Ender-3 V3 Neo, copied from the maker's data.
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
What to set
Set your slicer to
- Nozzle: 230–270 °C (446–518 °F).
- Bed: 35–70 °C (95–158 °F).
- Print speed: up to 100 mm/s.
The maker did not list an enclosure or a hardened nozzle.
Will it work on this printer?
- Ender-3 V3 Neo maximums: nozzle 300 °C (572 °F), bed 100 °C (212 °F).
- The listed nozzle temperature is within this printer's reach.
- The listed bed temperature is within this printer's reach.
- Whether an enclosure is required is not listed by the maker.
- A hardened nozzle is not listed by the maker.
Related
Where these numbers come from
Filament: eSUN TPE-95A TDS (CN, file V1.1, document dated 2026.06 v1.0) · checked 21 October 2026
Printer: Ender-3 V3 Neo · checked 19 October 2026
eSUN 3D TPE-95A (TPE) lists a nozzle temperature of 230–270 °C (446–518 °F) and a bed temperature of 35–70 °C (95–158 °F), drying at 60 °C (140 °F) for 5–7 h, and print speed up to 100 mm/s, from the eSUN TPE-95A TDS (https://www.esunchina.net/uploads/TPE-95A-TDS-CNV1.1.pdf), checked 2026-10-21.
A figure is copied from a named source, and a missing figure stays blank. Methodology.
The specification table lists nozzle temperature ≤300 °C (572 °F), heatbed temperature ≤100 °C (212 °F), a 220 × 220 × 220 mm build volume, and printing speed ≤500 mm/s.
The extruder is listed as Sprite 2 Extruder. The page does not call it direct drive, and it does not state a nozzle alloy, so those fields are empty.
Filament compatibility is recommended PLA, PETG, and TPU (90A TPU or harder), and supported ABS and ASA with an enclosure recommended. Auto filament refill and identification are listed as yes with CFS nano. The page does not say the printer itself is enclosed.