eSUN 3D TPE-95A on the Bambu Lab X1 Carbon
Published . Updated .
Print settings and compatibility for eSUN 3D TPE-95A on the Bambu Lab X1 Carbon, copied from the maker's data.
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
What to set
Set your slicer to
- Nozzle: 230–270 °C (446–518 °F).
- Bed: 35–70 °C (95–158 °F).
- Print speed: up to 100 mm/s.
The maker did not list an enclosure or a hardened nozzle.
Will it work on this printer?
- X1 Carbon maximums: nozzle 300 °C (572 °F), bed 110 °C (230 °F).
- The listed nozzle temperature is within this printer's reach.
- The listed bed temperature is within this printer's reach.
- Whether an enclosure is required is not listed by the maker.
- A hardened nozzle is not listed by the maker.
Related
Where these numbers come from
Filament: eSUN TPE-95A TDS (CN, file V1.1, document dated 2026.06 v1.0) · checked 21 October 2026
Printer: X1 Carbon tech specs PDF · checked 14 October 2026
eSUN 3D TPE-95A (TPE) lists a nozzle temperature of 230–270 °C (446–518 °F) and a bed temperature of 35–70 °C (95–158 °F), drying at 60 °C (140 °F) for 5–7 h, and print speed up to 100 mm/s, from the eSUN TPE-95A TDS (https://www.esunchina.net/uploads/TPE-95A-TDS-CNV1.1.pdf), checked 2026-10-21.
A figure is copied from a named source, and a missing figure stays blank. Methodology.
The tech specs PDF lists a hardened steel nozzle and a 300 °C (572 °F) maximum hot end temperature.
Maximum build plate temperature is listed as 110 °C (230 °F) at 220 V and 120 °C (248 °F) at 110 V. The number stored here is 110.
The PDF lists a chamber monitoring camera and says filament odometry is optional with AMS. It does not use the word enclosed, so enclosure is left empty.