eSUN 3D TPE-95A on the Bambu Lab P2S
Published . Updated .
Print settings and compatibility for eSUN 3D TPE-95A on the Bambu Lab P2S, copied from the maker's data.
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
What to set
Set your slicer to
- Nozzle: 230–270 °C (446–518 °F).
- Bed: 35–70 °C (95–158 °F).
- Print speed: up to 100 mm/s.
The maker did not list an enclosure or a hardened nozzle.
Will it work on this printer?
- P2S maximums: nozzle 300 °C (572 °F), bed 110 °C (230 °F).
- The listed nozzle temperature is within this printer's reach.
- The listed bed temperature is within this printer's reach.
- Whether an enclosure is required is not listed by the maker.
- A hardened nozzle is not listed by the maker.
Related
Where these numbers come from
Filament: eSUN TPE-95A TDS (CN, file V1.1, document dated 2026.06 v1.0) · checked 21 October 2026
Printer: P2S technical specifications · checked 15 October 2026
eSUN 3D TPE-95A (TPE) lists a nozzle temperature of 230–270 °C (446–518 °F) and a bed temperature of 35–70 °C (95–158 °F), drying at 60 °C (140 °F) for 5–7 h, and print speed up to 100 mm/s, from the eSUN TPE-95A TDS (https://www.esunchina.net/uploads/TPE-95A-TDS-CNV1.1.pdf), checked 2026-10-21.
A figure is copied from a named source, and a missing figure stays blank. Methodology.
The P2S technical specifications list a hardened steel nozzle, a 300 °C (572 °F) maximum nozzle temperature, and a 110 °C (230 °F) maximum heatbed temperature.
The product page describes printing with the door closed, a shatter-safe front glass, and a chamber that seals heat. The X2D comparison labels the P2S enclosed.
The product page also says the chamber is ready at 50 °C (122 °F). That is chamber air, not the heatbed maximum stored here.
Filament odometry on the specification is supported with AMS. The page does not say an AMS is in the box, and it does not name the extruder direct drive.