eSUN 3D TPE-95A on the Bambu Lab A1
Published . Updated .
Print settings and compatibility for eSUN 3D TPE-95A on the Bambu Lab A1, copied from the maker's data.
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
What to set
Set your slicer to
- Nozzle: 230–270 °C (446–518 °F).
- Bed: 35–70 °C (95–158 °F).
- Print speed: up to 100 mm/s.
The maker did not list an enclosure or a hardened nozzle.
Will it work on this printer?
- A1 maximums: nozzle 300 °C (572 °F), bed 100 °C (212 °F).
- The listed nozzle temperature is within this printer's reach.
- The listed bed temperature is within this printer's reach.
- Whether an enclosure is required is not listed by the maker.
- A hardened nozzle is not listed by the maker.
Related
Where these numbers come from
Filament: eSUN TPE-95A TDS (CN, file V1.1, document dated 2026.06 v1.0) · checked 21 October 2026
Printer: A1 FAQ · checked 14 October 2026
eSUN 3D TPE-95A (TPE) lists a nozzle temperature of 230–270 °C (446–518 °F) and a bed temperature of 35–70 °C (95–158 °F), drying at 60 °C (140 °F) for 5–7 h, and print speed up to 100 mm/s, from the eSUN TPE-95A TDS (https://www.esunchina.net/uploads/TPE-95A-TDS-CNV1.1.pdf), checked 2026-10-21.
A figure is copied from a named source, and a missing figure stays blank. Methodology.
The A1 FAQ states a maximum hotend temperature of 300 °C (572 °F) and a maximum heatbed temperature of 100 °C (212 °F).
The same FAQ says the printer is pre-installed with a 0.4 mm stainless steel nozzle. Hardened steel nozzles are sold separately.
The FAQ does not call the frame open or enclosed, so enclosure is left empty.