SUNLU ABS-GF on the Anycubic Kobra 3 Max V2
Published . Updated .
Print settings and compatibility for SUNLU ABS-GF on the Anycubic Kobra 3 Max V2, copied from the maker's data.
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
What to set
Set your slicer to
- Nozzle: 260–280 °C (500–536 °F).
- Bed: 90–100 °C (194–212 °F).
- Print speed: 50–300 mm/s.
The maker did not list an enclosure or a hardened nozzle.
Will it work on this printer?
- Kobra 3 Max V2 maximums: nozzle 300 °C (572 °F), bed 90 °C (194 °F).
- The listed nozzle temperature is within this printer's reach.
- This printer cannot reach the top of the listed bed range.
- Whether an enclosure is required is not listed by the maker.
- This filament is carbon-fiber, glass-fiber, or glow-in-the-dark, so a hardened nozzle is the upgrade to check. The stock nozzle is hardened.
Related
Where these numbers come from
Filament: SUNLU product page · checked 24 October 2026
Printer: Kobra 3 Max V2 Combo · checked 19 October 2026
SUNLU ABS-GF (ABS) lists a nozzle temperature of 260–280 °C (500–536 °F) and a bed temperature of 90–100 °C (194–212 °F), print speed 50–300 mm/s, and drying at 80 °C (176 °F), from the SUNLU product page (https://store.sunlu.com/products/sunlu-abs-gf-abs-glass-fiber-3d-printer-filament-1kg), checked 2026-10-24. Drying time is not stated on that page.
A figure is copied from a named source, and a missing figure stays blank. Methodology.
The specification table lists a hardened steel nozzle at a maximum of 300 °C (572 °F), standard diameter 0.4 mm, and a hotbed maximum of 90 °C (194 °F).
Extruder type is short distance extrusion with a dual-gear extruder. Recommended speed is 300 mm/s and the maximum is 600 mm/s.
ACE 2 Pro is listed as standard 4 colors, up to 8 colors, with drying up to 65 °C (149 °F). Supporting filaments are PLA, PETG, and TPU, and the table says TPU 95A is not compatible with the ACE 2 Pro.
The product FAQ says the Combo prints PLA, PETG, and TPU (68D), and that printing with PA and PC is not recommended. The page does not state an enclosure.