SUNLU ABS-GF on the Bambu Lab P2S
Published . Updated .
Print settings and compatibility for SUNLU ABS-GF on the Bambu Lab P2S, copied from the maker's data.
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
What to set
Set your slicer to
- Nozzle: 260–280 °C (500–536 °F).
- Bed: 90–100 °C (194–212 °F).
- Print speed: 50–300 mm/s.
The maker did not list an enclosure or a hardened nozzle.
Will it work on this printer?
- P2S maximums: nozzle 300 °C (572 °F), bed 110 °C (230 °F).
- The listed nozzle temperature is within this printer's reach.
- The listed bed temperature is within this printer's reach.
- Whether an enclosure is required is not listed by the maker.
- This filament is carbon-fiber, glass-fiber, or glow-in-the-dark, so a hardened nozzle is the upgrade to check. The stock nozzle is hardened.
Related
Where these numbers come from
Filament: SUNLU product page · checked 24 October 2026
Printer: P2S technical specifications · checked 15 October 2026
SUNLU ABS-GF (ABS) lists a nozzle temperature of 260–280 °C (500–536 °F) and a bed temperature of 90–100 °C (194–212 °F), print speed 50–300 mm/s, and drying at 80 °C (176 °F), from the SUNLU product page (https://store.sunlu.com/products/sunlu-abs-gf-abs-glass-fiber-3d-printer-filament-1kg), checked 2026-10-24. Drying time is not stated on that page.
A figure is copied from a named source, and a missing figure stays blank. Methodology.
The P2S technical specifications list a hardened steel nozzle, a 300 °C (572 °F) maximum nozzle temperature, and a 110 °C (230 °F) maximum heatbed temperature.
The product page describes printing with the door closed, a shatter-safe front glass, and a chamber that seals heat. The X2D comparison labels the P2S enclosed.
The product page also says the chamber is ready at 50 °C (122 °F). That is chamber air, not the heatbed maximum stored here.
Filament odometry on the specification is supported with AMS. The page does not say an AMS is in the box, and it does not name the extruder direct drive.