Anycubic PLA Silk on the P1S
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle—
- Bed—
- Speed—
- Dry50 °C maximum
- Density1.23 g/cm³
No nozzle or bed temperature on the source. Dry at 50 °C if it's been open. No drying time on the source.
P1S maximums: nozzle 300 °C, bed 100 °C.
Sources & notes
Bambu Lab P1S with Anycubic PLA Silk: Nozzle temperature is not in our current sources.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
The P1S specification table lists a stainless steel nozzle, a 300 °C maximum hot end, and a 100 °C maximum build plate. The shell is plastic and glass.
Bambu Lab describes the P1S as a fully enclosed body and says fiber-reinforced filament is not recommended until the extruder and hotend are upgraded.
The P1 series page describes a direct-drive extruder and AMS multi-color printing.
Questions
Can the Bambu Lab P1S reach the listed PLA Silk nozzle temperature?
Nozzle temperature is not in our current sources.
Can the P1S reach the listed bed temperature?
Bed temperature is not in our current sources.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
A hardened nozzle is not recorded for this filament.