Partial
Polymaker HT-PLA-GF on the P1P
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle210–230 °C (410–446 °F)
- Bed25–60 °C (77–140 °F)
- Speedup to 350 mm/s
- Dry60 °C (140 °F) for 6 h
- Density1.33 g/cm³
Print at 210–230 °C (410–446 °F) nozzle, 25–60 °C (77–140 °F) bed. Dry 6 h at 60 °C (140 °F) if it's been open. Listed speed up to 350 mm/s.
P1P maximums: nozzle 300 °C (572 °F), bed 100 °C (212 °F).
Sources & notes
Bambu Lab P1P with Polymaker HT-PLA-GF: This filament is recorded as needing a hardened nozzle. The stock nozzle is not hardened.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
The P1S store comparison lists the P1P shell as an open frame, a stainless steel nozzle, a 300 °C maximum hot end, and a 100 °C maximum build plate.
The P1 series page describes a direct-drive extruder and multi-color printing with the AMS.
Questions
Can the Bambu Lab P1P reach the listed HT-PLA-GF nozzle temperature?
The listed nozzle maximum of 230 °C (446 °F) is within this printer's maximum of 300 °C (572 °F).
Can the P1P reach the listed bed temperature?
The listed bed maximum of 60 °C (140 °F) is within this printer's maximum of 100 °C (212 °F).
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
This filament is recorded as needing a hardened nozzle. The stock nozzle is not hardened.