Partial
Bambu Lab PPA-CF on the SV08 Max
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle—
- Bed100–120 °C
- Speedup to 100 mm/s
- Dry—
- Density1.25 g/cm³
Bed 100–120 °C. No nozzle temperature on the source. Listed speed up to 100 mm/s.
SV08 Max maximums: nozzle 300 °C, bed 100 °C.
Sources & notes
Sovol SV08 Max with Bambu Lab PPA-CF: The listed bed range reaches 120 °C, above this printer's maximum of 100 °C. This printer cannot reach the full recommended range. The low end, 100 °C, is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Bambu Lab PPA-CF technical data sheet · checked 14 October 2026 · Printer source · Filament JSON
Sovol lists nozzle temperature ≤300 °C and hot bed temperature ≤100 °C, plus an optional chamber heating module and an enclosure kit.
Sovol's product note describes a dual-gear direct drive extruder. Nozzle alloy is not stated.
Questions
Can the Sovol SV08 Max reach the listed PPA-CF nozzle temperature?
Nozzle temperature is not in our current sources.
Can the SV08 Max reach the listed bed temperature?
The listed bed range reaches 120 °C, above this printer's maximum of 100 °C. This printer cannot reach the full recommended range. The low end, 100 °C, is within that maximum.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
This filament is recorded as needing a hardened nozzle. Whether the stock nozzle is hardened is not in our current sources.