Partial
Polymaker PVA PolySupport for PA12 on the XL
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle270–300 °C
- Bed50–80 °C
- Speed—
- Dry—
- Density1.29 g/cm³
Print at 270–300 °C nozzle, 50–80 °C bed.
XL maximums: nozzle 290 °C, bed 120 °C.
Sources & notes
Prusa XL with Polymaker PVA PolySupport for PA12: The listed nozzle range reaches 300 °C, above this printer's maximum of 290 °C. This printer cannot reach the full recommended range. The low end, 270 °C, is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
The comparison table lists the XL at 290 °C / 120 °C with a brass nozzle and multi-material printing by up to five toolheads.
Chamber temperature is listed as 45 °C in the Enclosure, which is treated here as an optional enclosure rather than a stock enclosed chamber.
Questions
Can the Prusa XL reach the listed PVA PolySupport for PA12 nozzle temperature?
The listed nozzle range reaches 300 °C, above this printer's maximum of 290 °C. This printer cannot reach the full recommended range. The low end, 270 °C, is within that maximum.
Can the XL reach the listed bed temperature?
The listed bed maximum of 80 °C is within this printer's maximum of 120 °C.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
A hardened nozzle is not recorded for this filament.